If a wheel is bent, cracked or heavily corroded, it should be replaced. Otherwise, the tire may separate from the wheel or cause a loss of handling control.
Monitor description
While the engine is being cranked, the battery positive voltage is applied to
terminal sta of the ecm.
If the ecm detects the starter control signal (sta) while the vehicle is
driving, it will conclude that there is
a fault in the starter control circuit. The ecm will turn on the mil and a d ...
Circuit description
Refer to dtc p0335
Dtc no.
Dtc detection condition
Trouble area
P0016
Deviation in crankshaft position sensor signal and camshaft
position sensor signal (2 trip detection logic)
Mechanical system (timing chain has jumped a tooth, chain
stretch ...
Inspection procedure
Hint:
start the inspection from step 1 in case of using the hand–held tester and start
from step 2 in case of not
using hand–held tester.
1 Inspect brake actuator assy
Select the datalist mode on the hand–held tester.
check the operation sound of the abs pump motor when operating it ...