Toyota Corolla (E170): Vehicle exterior

CAUTION

CAUTION

■If the engine is running

Turn the engine off and ensure that there is adequate ventilation before performing maintenance checks.

    Share this page:

    Other materials:

    Inspection procedure
    1 Input signal check See the input signal check on page 05–745.  check the indicator light when the clutch pedal is depressed. Ok: the indicator light goes off when the clutch pedal is depressed. 2 Inspect terminal voltage(d) Turn the ignition switch to on. &n ...

    Body rocker panel moulding lh
    Replacement Hint: use the same procedures for the rh side and lh side. 1. Remove body rocker panel moulding lh Remove the 8 retainers.  using a screwdriver, remove the moulding. Hint: tape the screwdriver tip before use.  remove the 7 clips from the moulding. 2. Insta ...

    Adjustment
    1. Inspect and adjust clutch pedal sub–assy Turn over the floor carpet.  check that the pedal height is correct. Pedal height from asphalt sheet: 135.8 – 145.8 Mm (5.346 – 5.740 In.)  adjust the pedal height. Loosen the lock nut and turn the stopper bolt until ...