Toyota Corolla (E170): Stopping

► Automatic transmission or continuously variable transmission

1 With the shift lever in D, depress the brake pedal.

2 If necessary, set the parking brake.

If the vehicle is to be stopped for an extended period of time, shift the shift lever to P or N. (, 174, 176) ►  Manual transmission

1 While depressing the clutch pedal, depress the brake pedal.

2 If necessary, set the parking brake.

If the vehicle is to be stopped for an extended period of time, shift the shift lever to N.

    Share this page:

    Other materials:

    Side mudguard sub–assy lh
    Replacement Hint: use the same procedures for the rh side and lh side. 1. Remove side mudguard sub–assy lh Using a clip remover, remove the 8 retainers and 9 clips.  using a moulding remover, remove the mudguard. 2. Install side mudguard sub–assy lh Install the mudgu ...

    Inspection procedure
    Hint: this dtc chart is on the premise that the engine is cranked normally. If the engine is not cranked, proceed to the problem symptoms table on page 05–42. Read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze frame data records the engine conditions ...

    If the engine will not start
    If the engine will not start even though correct starting procedures are being followed , consider each of the following points: The engine will not start even though the starter motor operates normally. One of the following may be the cause of the problem: ● There may not be sufficient f ...