Toyota Corolla (E170): Shifting the shift lever to R

Shift the shift lever to R while lifting up the ring section.

■Maximum allowable speeds

■Maximum allowable speeds

Observe the following maximum allowable speeds in each gear when maximum acceleration is necessary.

mph (km/h)

NOTICE

NOTICE

■To prevent damage to the transmission

●Do not lift up the ring section except when shifting the lever to R.

●Shift the shift lever to R only when the vehicle is stationary.

●Do not shift the shift lever to R without depressing the clutch pedal.

Turn signal lever

    Share this page:

    Other materials:

    Inspection procedure
    1 Check side squib(lh) circuit(airbag sensor assy center – front seat airbag assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...

    Inspection procedure
    1 Check fuse(ecu–ig) Remove the ecu–ig fuse from the instrument panel j/b.  check the continuity of the ecu–ig fuse. Ok: continuity 2 Inspect terminal voltage(b) Remove the cruise control ecu assy with connector still connected.  turn the ignition switch ...

    Replacement
    Hint: components: 1. Precaution 2. Disconnect battery negative terminal 3. Remove air bag front rh sensor Disconnect the connector from the airbag front rh sensor.  remove the 2 bolts and airbag front rh sensor. 4. Inspect air bag front rh sensor 5. Install air bag front rh ...