Toyota Corolla (E170): Setting the alarm system

Close the doors, trunk and hood, and lock all the doors. The system will be set automatically after 30 seconds.

The indicator light changes from being on to flashing when the system is set.

Deactivating or stopping the alarm

    Share this page:

    Other materials:

    Electronic control
    Removal and installation of battery terminal  before performing electrical work, disconnect the battery negative (–) terminal cable beforehand so as to prevent burnt–out damage by short.  When disconnecting and installing the terminal cable, turn the ignition switch an ...

    BSM (Blind Spot Monitor)
    The Blind Spot Monitor is a system that uses rear side radar sensors installed on the inner side of the rear bumper on the left and right side to assist the driver in confirming safety when changing lanes. WARNING ■Cautions regarding the use of the system The driver is solely responsible for sa ...

    Rear suspension
    Service data Torque specification Tire&wheel Service data Drive shaft / propeller shaft / axle Service data Torque specification ...