Toyota Corolla (E120): Roof antenna pole sub–assy

Replacement

Hint

: components:

1. Remove roof antenna pole sub–assy

  1. Remove the roof antenna pole by turning it in the arrow direction in the illustration.
    Share this page:

    Other materials:

    Fail–safe chart
    If any of the following codes is recorded, the ecm enters the fail–safe mode. Check for intermittent problems Hand–held tester only: by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is possible instead of the 2 trip detection logic, and the sensitivity to de ...

    Circuit description
    The camshaft position sensor (g22+ signal) consists of a magnet, iron core and pickup coil. The g22+ signal plate has 3 teeth on its outer circumference and is installed on the camshaft timing pulley. When the camshafts rotate, the protrusion on the signal plate and the air gap on the pi ...

    Removal & installation and disassembly & reassembly
    1. Remove bench type rear seat cushion assy 2. Remove rear floor service hole cover Remove the rear service hole cover. Disconnect the fuel pump and vapor pressure sensor connector. 3. Work for preventing gasoline from spilling out Start the engine.  after the engi ...