Toyota Corolla (E120): Rear seat belt

Share this page:

Other materials:

Malfunction in tachometer
Wiring diagram Inspection procedure Check output value of ecm.  Connect the hand–held tester to dlc3. Turn the ignition switch to on and push the hand–held tester main switch on.  Select the data list mode on the hand–held tester. 2 Inspect combinatio ...

Inspection procedure
1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...

Things you should know
■ If you notice any symptoms If you notice any of the following symptoms, refer to the likely cause and the solution, and re-check. If the symptom is not resolved by the solution, have the vehicle inspected by your Toyota dealer. CAUTION ■When using the rear view monitor system ...