Toyota Corolla (E120): Rear door

Share this page:

Other materials:

Adjustment
Hint: in the rh side, work in the same procedure as in the lh side. Since the centering bolt is used as a door side hinge bolt, the door hinge cannot be adjusted with it on. Substitute the bolt with washer for the centering bolt. 1. Inspect front door panel sub–assy lh Che ...

Inspection procedure
1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...

Circuit description
The door key lock and unlock switch is built in the door lock motor. Wiring diagram Inspection procedure 1 Check door lock 2 Check wire harness (tvip ecu  door lock) Disconnect the tvip ecu and door lock connectors.  check the continuity between the terminals of the t ...