Toyota Corolla Owners Manual: Dialing from call history
You can make a call using the call history, which has the 3 functions below.
: calls which you missed
: calls which you received
: calls which you made
1 Display the phone screen. 2 Select “Call History” tab.
3 Select 
or the desired entry from
the list.
► When
is selected
4 Check that the “Call” screen is displayed.
► When the desired contact is selected
5 Select the desired number.
6 Check that the “Call” screen is displayed.
■Call history list
●If you make a call to or receive a call from a number registered in the contact, the name is displayed in the call history.
●If you make multiple calls to the same number, only the last call made is displayed in the call history.
■International calls
You may not be able to make international calls, depending on the mobile phone in use.
Calling using favorites list
You can make a call using numbers registered in the contact.
1 Display the phone screen.
2 Select “Favorites” tab.
3 Select the desired number to make a call. ...
Receiving a call
When a call is received, the following screen is displayed together with a
sound.
To answer the phone
Press the switch on the steering
wheel or select .
To refuse a call
Press the switch o ...
Other materials:
Inspection
1. Spark plug
Notice:
never use a wire brush for cleaning.
Never attempt to adjust the electrode gap on used
spark plug.
Spark plug should be replaced every 192,000 km
(120,000 miles).
Clean the spark plugs.
Air pressure: below 588 kpa (6.0 Kg/cm2, 85 psi)
duration: 20 sec ...
Inspection procedure
Hint:
when the throttle position is slightly opened (the accelerator pedal
is slightly depressed) because a
floor carpet is overlapped on the accelerator pedal, or if not fully
releasing the accelerator pedal, etc.,
Dtc p505 will possibly be detected.
Read freeze frame data using the ...
Inspection procedure
1 Check relay (marking: starter cut)
Inspect the relay continuity, as shown in the illustration
and table.
Standard:
2 Check tvip ecu
Disconnect the tvip ecu connector.
turn the ignition switch position to the start.
measure the voltage between the termina ...