Toyota Corolla (E170): Connecting a Bluetooth® audio player

► Registering an additional device Select “Select Device” on the Bluetooth® audio control screen.

►Selecting a registered device Select “Select Device” on the Bluetooth® audio control screen.

■Reconnecting a Bluetooth® phone

If the system cannot connect due to poor signal strength with the engine switch in ACCESSORY or ON <IGNITION ON> mode, the system will automatically attempt to reconnect.

If the phone is turned off, the system will not attempt to reconnect. In this case, the connection must be made manually, or the phone must be reselected.

    Share this page:

    Other materials:

    Problem symptoms table
    Hint: use the table below to help determine the cause of the problem. The numbers indicate the priority of the likely cause of the problem. Check each part in order. If necessary, replace these parts. 1. Headlamp and tail lamp 2. Front fog lamp system 3. Turn signal and hazard warni ...

    Inspection procedure
    1 Check side squib(rh) circuit(airbag sensor assy center – front seat airbag assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...

    LTA (Lane Tracing Assist)
    LTA functions When driving on a road with clear lane lines with the dynamic radar cruise control operating, lane lines and preceding and surrounding vehicles are detected using the front camera and radar sensor, and the steering wheel is operated to maintain the vehicle's lane position. ...