Toyota Corolla (E120): Clutch system (mtm)

Problem symptoms table

Hint:

use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely cause of the problem. Check each part in order. If necessary, replace these parts.

Clutch pedal sub–assy (mtm)

    Share this page:

    Other materials:

    Inspection procedure
    Hint: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using the hand–held tester. 1 Read value of hand–held tester(skid control sensor) Check that there is no difference between the speed value output from the speed sensor ...

    Replacement
    1. Remove engine under cover rh 2. Remove fan and generator v belt 3. Remove generator assy Disconnect the wire clamp from the wire clip on the rectifire end frame.  remove the rubber cap and nut, and disconnect the alternator wire.  disconnect the alternator connecto ...

    Torque converter clutch and drive plate (atm)
    Inspection 1. Inspect torque converter clutch assy Inspect the one–way clutch.  Set sst into the inner race of the one–way clutch. Sst 09350–32014 (09351–32010)  set sst so that it fits in the notch of the converter hub and outer race of the one–way clutch. ...