Toyota Corolla (E120): Circuit description

The wireless receiver receives a set/unset signal for the tvip system and sends the signal to the tvip ecu via the integration relay.

Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    Radio broadcast cannot be received (bad reception)
    Inspection procedure 1 Check if radio auto–search functions properly Check if the radio auto–search functions properly.  Perform the auto–search of the radio and check that it functions normally. Standard: the radio auto–search functions properly. 2 Check optional ...

    On–vehicle inspection
    1. Inspection throttle body idle speed control valve assy Notice: it is impossible to check the resister value and the operation of isc valve by itself, because the isc valve has an ic circuit inside it, which transforms the duty signal from the ecm to the derive signal. After check ...

    Inspection procedure
    1 Check hazard warning signal switch assy Check the hazard warning switch continuity, as shown in the illustration and table. Standard: 2 Check turn signal flasher assy 3 Check wire harness (tvip ecu turn signal flasher) Disconnect the tvip ecu and turn signal flashe ...