Toyota Corolla (E120): Wiring diagram
1 Inspect terminal voltage(pi) (a) turn
- Turn the ignition switch to on.
- measure voltage between terminal 5 (pi) of cruise control
ecu assy and body ground, when the cruise control main
switch button is on and off.
Ok:
2 Inspect combination meter assy
3 Check harness and connector(between cruise control ecu assy and combination meter assembly)
- Check for open and short circuit in harness and connector between cruise control ecu assy and combination meter assembly
Check and replace cruise control ecu assy
Other materials:
Circuit description
The throttle pressure that is applied to the primary regulator
valve (which modulates the line pressure) causes the solenoid
valve slt, under electronic control, to precisely and minutely
modulate and generate the line pressure according the extent
of the accelerator pedal depressed or the o ...
System description
The ecm uses signals from the vehicle speed sensor and crankshaft position
sensor to detect the actual
gear position (1st, 2nd, 3rd or o/d gear).
Then the ecm compares the actual gear with the shift schedule in the ecm memory
to detect the mechanical
trouble of the shift solenoid valves, th ...
If the engine will not start
If the engine will not start even though correct starting procedures are being
followed , consider each of the following points:
The engine will not start even though the starter motor operates normally.
One of the following may be the cause of the problem:
● There may not be sufficient f ...