Toyota Corolla (E120): Wiper rubber lh

Replacement

1. Remove fr wiper blade lh

  1.  remove the front wiper blade lh from the front wiper arm lh.

Notice

: do not fold down the front wiper arm with the front wiper blade being removed from it.

2. Remove wiper rubber lh

  1.  remove the front wiper rubber lh from the front wiper blade.
  2.  remove the 2 wiper rubber backing plates from the wiper rubber lh.

3. Install wiper rubber lh

  1. Install the 2 wiper rubber backing plates to the wiper rubber lh.

Notice

: be careful to observe and keep direction of curvature for correct replacement.

  1. Install the wiper rubber lh so that the head part (larger side) of the wiper rubber faces the arm axie side.

Notice

: push the front wiper blade into the grooves of the wiper rubber to engage them completely.

    Share this page:

    Other materials:

    On–vehicle inspection
    1. Check fuel pump operation Connect the hand–held tester to the dlc3.  turn the ignition switch on and hand–held tester main switch on. Notice: do not start the engine.  select the active test mode on the hand–held tester.  please refer to the hand–held te ...

    Malfunction in tachometer
    Wiring diagram Inspection procedure Check output value of ecm.  Connect the hand–held tester to dlc3. Turn the ignition switch to on and push the hand–held tester main switch on.  Select the data list mode on the hand–held tester. 2 Inspect combinatio ...

    Speedometer sensor (atm)
    Replacement 1. Remove air cleaner case 2. Remove air cleaner hose no.1 3. Remove speedometer sensor  disconnect the connector.  remove the bolt and speedometer sensor assembly.  remove the clip and driven gear from the speedometer sensor. 4. Install speedometer sensor ...