Toyota Corolla (E120): Wiper & washer

Share this page:

Other materials:

Inspection procedure
1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...

Rear combination lamp assy lh
Replacement Using a clipremover, remove the 2 clips and disconnect the luggage compartment trim cover lh. Disconnect the connector and remove the 3 nuts. Pull out the rear combination light assy lh to the back of the vehicle, and remove. ...

On–vehicle inspection
1. Inspect drive belt Visually check the belt for excessive wear, frayed cords, etc. If any defect is found, replace the drive belt. Hint: cracks on the rib side of a belt are considered acceptable. If the missing chunks from the ribs are found on the belt, it should be replaced. 2 ...