Toyota Corolla (E120): W/receiver condenser assy

Share this page:

Other materials:

Inspection procedure
1 Check hazard warning signal switch assy Check the hazard warning switch continuity, as shown in the illustration and table. Standard: 2 Check turn signal flasher assy 3 Check wire harness (tvip ecu turn signal flasher) Disconnect the tvip ecu and turn signal flashe ...

Inspection procedure
1 Check d squib circuit(airbag sensor assy center – horn button assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the horn button assy and the airbag sensor assy center.  for the oran ...

Adjusting the set speed
To change the set speed, operate the lever until the desired set speed is obtained. 1 Increases the speed 2 Decreases the speed Fine adjustment: Momentarily move the lever in the desired direction. Large adjustment: Hold the lever in the desired direction. The set speed will be increased or dec ...