Toyota Corolla (E170): Vehicle specifications

Share this page:

Other materials:

Inspection procedure
1 Check hazard warning signal switch assy Check the hazard warning switch continuity, as shown in the illustration and table. Standard: 2 Check turn signal flasher assy 3 Check wire harness (tvip ecu turn signal flasher) Disconnect the tvip ecu and turn signal flashe ...

Cd sound skips
Inspection procedure 1 Disc cleaning Disk cleaning ) if the disk gets dirty, clean the disk by wiping the surface from the center to outside in the radial directions with a soft cloth. Notice: do not use a conventional record cleaner or anti–static preservative. Standard: ...

Skid control sensor
Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire Disconnect the skid control sensor wire connector from the skid control sensor. 4. Remove rear axle hub & ...