Toyota Corolla (E170): Vehicle information

This screen can be used to display the fuel consumption.

“Trip Information” or “Past Record” screen

Press “CAR” to display the “Trip Information” or “Past Record” screen.

Fuel consumption

■ Trip information

If the “Trip Information” screen does not appear, select “Trip Information”.

1 Average vehicle speed 2 Elapsed time
3 Range
4 Previous fuel consumption per minute 5 Current fuel consumption 6 Reset the trip information data 7 “Past Record” screen appears

These images are examples only, and may vary slightly from actual conditions.

■ Past record

■ Past record

If the “Past Record” screen does not appear, select “Past Record”.

1 Previous fuel economy record 2 Current fuel economy
3 Best recorded fuel economy 4 Update the past record data 5 Reset the past record data 6 “Trip Information” screen appears 7 Average recorded fuel economy

These images are examples only, and may vary slightly from actual conditions.

■Resetting the data

Selecting “Clear” on the consumption screen will reset the consumption data.

Selecting “Clear” on the “Past Record” screen will reset the past record data.

■Updating the past record data

Selecting “Update” on the “Past Record” screen will update the past record data.

    Share this page:

    Other materials:

    Inspection procedure
    1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the instrument panel ...

    On–vehicle inspection
    1. Check cooling fan operation with low temperature (below 83 c (181 f)) Turn the ignition switch on.  check that the cooling fan stops. Hint: if not, check the cooling fan relay and water temperature sensor, and check for separated connector or severed wire between the cooling fan ...

    Valve clearance
    Adjustment 1. Remove cylinder head cover no.2 Remove the 2 nuts, 2 clips and cylinder head cover. 2. Disconnect engine wire Remove the 5 clamps from the 5 clamp brackets. Disconnect the 4 ignition coil connectors. Remove the bolt and nut installing the engine wire ...