Toyota Corolla (E170) 2014–2019 Owners Manual / Maintenance and care / Maintenance / General maintenance / Vehicle exterior
Toyota Corolla (E170): Vehicle exterior

CAUTION
■If the engine is running
Turn the engine off and ensure that there is adequate ventilation before performing maintenance checks.
Other materials:
Shift position uses
*: Shifting to the D position allows the system to select a gear suitable for
driving conditions. Setting the shift lever to the D position is recommended for
normal driving.
■Downshifting restrictions
The shift lever cannot be downshifted if the following speeds are exceeded.
mph (km ...
Oxygen sensor monitor (front and rear o2s system)
Preconditions
The monitor will not run unless:
mil is off
drive pattern
connect the obd ii scan tool to the dlc3 to check monitor status
and preconditions.
Start the engine and allow it to idle for 2 minutes or more.
Drive the vehicle at 25 mph ...
Inspection procedure
1 Inspect ecm(+b voltage)
Turn the ignition switch on.
measure the voltage between the terminals of the e4 and
e6 ecm connectors.
Standard:
2 Check harness and connector(ecm – body ground)
Disconnect the e4 ecm connector.
check the resistance between the wire ...


