Toyota Corolla (E170): Using Bluetooth® devices

Share this page:

Other materials:

On–vehicle inspection
1. Check fuel pump operation Connect the hand–held tester to the dlc3.  turn the ignition switch on and hand–held tester main switch on. Notice: do not start the engine.  select the active test mode on the hand–held tester.  please refer to the hand–held te ...

Diagnostic trouble code chart
The inspection procedures are shown in the table below. This table allows efficient and accurate troubleshooting using the diagnostic trouble codes displayed in the diagnostic trouble code chart. Proceed with troubleshooting in accordance with the inspection procedures listed in the diagnost ...

Thermostat
Replacement 1. Remove engine under cover rh 2. Drain coolant 3. Remove fan and generator v belt 4. Remove generator assy Disconnect the wire clamp from the wire clip on the rectifire end frame.  remove the rubber cap and nut, and disconnect the alternator wire.  d ...