Toyota Corolla (E170): Unlocking and locking the doors from the outside

◆ Smart key system (if equipped)

Carry the electronic key to enable this function.

1 Grip the driver’s door handle to unlock the door. Grip the passenger’s door handle to unlock all the doors.* Make sure to touch the sensor on the back of the handle.

The doors cannot be unlocked for 3 seconds after the doors are locked.

*: The door unlock settings can be changed. 2 Touch the lock sensor (the indentation on the upper part of the door handle) to lock all the doors.

◆ Wireless remote control (if equipped)

◆ Wireless remote control (if equipped)

► Vehicles without a smart key system

1 Locks all the doors 2 Unlocks all the doors

Pressing the button unlocks the driver’s door. Pressing the button again within 5 seconds unlocks the other doors.

► Vehicles with a smart key system

► Vehicles with a smart key system

1 Locks all the doors 2 Unlocks all the doors

Pressing the button unlocks the driver’s door. Pressing the button again within 5 seconds unlocks the other doors.

◆ Key

◆ Key

Turning the key operates the doors as follows:

► Vehicles without a smart key system

1 Locks all the doors 2 Unlocks all the doors Driver’s side only: Turning the key unlocks the driver's door.

Turning the key again unlocks the other doors.

► Vehicles with a smart key system The doors

► Vehicles with a smart key system The doors can also be locked and unlocked with the mechanical key.

■Operation signals

A buzzer sounds and the emergency flashers flash to indicate that the doors have been locked/unlocked. (Locked: once; Unlocked: twice) ■Security feature

If a door is not opened within approximately 60 seconds after the vehicle is unlocked, the security feature automatically locks the vehicle again.

■When the door cannot be locked by the lock sensor on the upper part of the door handle

If the door will not lock even when the topside sensor area is touched, try using your palm to touch the lock sensor.

■Door lock buzzer

■Door lock buzzer

If an attempt to lock the doors using the wireless remote control or smart key system is made when a door is not fully closed, a buzzer will sound for 5 seconds.

Fully close the door, and lock the vehicle again.

■Setting the alarm (if equipped)

Locking the doors will set the alarm system. ■If the smart key system or the wireless remote control does not operate properly

Use the mechanical key to lock and unlock the doors. Replace the battery with a new one if it is depleted.

    Share this page:

    Other materials:

    Inspection procedure
    1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the instrument panel ...

    Registering and connecting from the “Bluetooth* Setup” screen
    To display the screen shown below, press the “SETUP” button and select “Bluetooth*” on the “Setup” screen. 1 Select to connect the device to be used with multimedia system. 2 Select to register a Bluetooth® device to be used with multimedia system. 3 Select to set detailed Bluet ...

    For your information
    Main Owner’s Manual Please note that this manual applies to all models and explains all equipment, including options. Therefore, you may find some explanations for equipment not installed on your vehicle. All specifications provided in this manual are current at the time of printing. Howeve ...