Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Audio system / Turning on light switch does not light up night time illumination of radio receiver

Toyota Corolla (E120): Turning on light switch does not light up night time illumination of radio receiver

Wiring diagram

Inspection procedure

Inspection procedure

1 Inspect radio receiver assy(ill+, ill–)

  1. Check that the voltage between terminals at each condition, as shown in the chart.

Standard:

Repair or replace harness or connector

Repair or replace harness or connector

    Share this page:

    Other materials:

    Circuit description
    The purpose of this circuit is to prevent the engine from stalling while driving in lock–up condition, when brakes are suddenly applied. When the brake pedal is depressed, this switch sends a signals to the ecm. Then the ecm cancels the operation of the lock–up clutch while braking is i ...

    Speedometer sensor (atm)
    Replacement 1. Remove air cleaner case 2. Remove air cleaner hose no.1 3. Remove speedometer sensor  disconnect the connector.  remove the bolt and speedometer sensor assembly.  remove the clip and driven gear from the speedometer sensor. 4. Install speedometer sensor ...

    Check open circuit
    For the open circuit in the wire harness in fig. 1, Perform a resistance check in step (b) or a voltage check in step (c) to locate the section. Check the resistance.  Disconnect connectors a and c and measure the resistance between them. Resistance: 1 Ω or les ...