Toyota Corolla (E120) 2002–2008 Repair Manual / Theft deterrent & door lock / Transmitter battery
Toyota Corolla (E120): Transmitter battery
Replacement
1. Replace transmitter battery
Notice:
special caution should be taken for handling each component as they are precision electronic components.
- Using a screwdriver, pry out the transmitter case.
Notice
: do not forcibly pry out the case.
Hint
: tape the screwdriver tip before use.
- Remove the battery (lithium battery).
Notice
:
- do not push the terminals with your finger.
- Prying up the battery (lithium battery) to forcibly remove it will cause deformation of the terminals.
- Do not touch the battery with wet hands. Water may cause unexpected rust.
- Do not touch or move any components inside the transmitter as it may interfere with proper operation.
2. Install transmitter battery
- install a new battery (lithium battery) with the positive (+) side up, as shown in the illustration.
Notice
:
- be sure that the positive side and the negative side of the transmitter battery are matched–up correctly.
- Be careful not to bend the electrode of the transmitter battery insertion.
- Be careful that dust or oil does not adhere to the transmitter case.
- install the case securely.
Other materials:
Ecm (1zz–fe)
Replacement
1. Disconnect battery negative terminal
2. Remove glove compartment door assy
3. Remove ecm
Remove the 2 clips using a clip remover. Then, open the
cover.
Disconnect the 4 ecm connectors.
remove the wire harness from the wire harness clamp.
Remove the 2 ...
Bluetooth® device registration status
1 Display the “Bluetooth* Setup” screen.
*: Bluetooth is a registered trademark of Bluetooth SIG, Inc.
2 Select the device.
3 Select “Device Info”.
4 Following screen is displayed:
1 Device Name
2 Change connection method
3 Bluetooth® Address
4 Display your telephone number
The n ...
On–vehicle inspection
1. Washer motor
Operation check
pour the water into the washer jar with the washer
motor and the pump installed to the washer jar assy.
Connect the battery (+) to terminal 2 of the washer
motor and the pump, the battery (–) to terminal 1 of
the washer motor and the pump ...