Toyota Corolla (E120) 2002–2008 Repair Manual / Automatic transmission / trans / Transmission wire (atm)
Toyota Corolla (E120): Transmission wire (atm)
Replacement
1. Remove transmission valve body assy
2. Remove transmission wire
- Disconnect the transmission wire connector.
- removal the bolt and transmission wire.
3. Install transmission wire
- Coat a o–ring with atf.
- install the transmission wire and bolt.
Torque: 5.4 Nvm (55 Kgf·cm, 48 in.Vlbf)
- connect the transmission wire connector.
4. Install transmission valve body assy
Other materials:
Transmitter battery
Replacement
1. Replace transmitter battery
Notice:
special caution should be taken for handling each component as they are
precision electronic components.
Using a screwdriver, pry out the transmitter case.
Notice:
do not forcibly pry out the case.
Hint:
tape the screwdriver tip ...
Disposal
1. Dispose shock absorber assy front lh
fully extend the shock absorber piston rod.
using a drill, make a hole in the cylinder as shown in the
illustration to discharge the gas inside.
Caution:
when drilling, chips may fly out, work carefully.
The gas is colorless, o ...
Identification information
Vehicle identification and serial numbers
1. Vehicle identification number
The vehicle identification number is stamped on the vehicle
identification number plate and certification label, as
shown in the illustration.
Vehicle identification number plate
certification label
2. Engine ...