Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Toyota vehicle intrusion protection system
Toyota Corolla (E120): Toyota vehicle intrusion protection system
- How to proceed with troubleshooting
- Terminals of ecu
- Problem symptoms table
- Indicator light circuit
- Ecu power source circuit
- Ignition switch circuit
- Horn relay circuit
- Light control switch circuit
- Hazard warning switch circuit
- Starter cut relay circuit
- Key unlock warning switch circuit
- Glass breakage sensor circuit
- Door courtesy switch circuit
- Door unlock detection switch circuit
- Door key lock and unlock switch circuit
- Tvip ecu communication circuit
Other materials:
Radio receiver assy
Replacement
Рint: components:
1. Remove floor shift shift lever knob sub–assy (m/t transaxle)
2. Remove console panel upper
3. Remove heater control knob
4. Remove instrument cluster finish panel
5. Remove instrument cluster finish panel sub–assy
center
Remove the 4 screws.
& ...
Clock assy
Replacement
1. Remove console panel upper
2. Remove heater control knob
3. Remove instrument cluster finish panel
4. Remove clock assy
Using a screwdriver, disengage the 4 claws, remove the
clock as shown in the illustration.
Hint:
tape the screwdriver tip before use. ...
Inspection procedure
Hint:
start the inspection from step 1 in case of using the hand–held tester and start
from step 2 in case of not
using the hand–held tester.
1 Read value of hand–held tester(skid control sensor)
Check that there is no difference between the speed value output from
the speed sensor ...


