Toyota Corolla (E140) 2007–2013 Body Repair Manual
Toyota Corolla (E140) 2007–2013 Body Repair Manual
Other materials:
Removal & installation and disassembly & re
1. Remove bench type rear seat cushion assy (, 72–8)
2. Remove rear floor service hole cover
3. Work for preventing gasoline from spilling out
start the engine.
after the engine has stopped on the its own, turn the ignition
switch to lock.
4. Disconnect fuel tank main tu ...
On–vehicle inspection
1. Inspect turn signal flasher relay circuit
Disconnect the connector from the turn signal flasher
relay and inspect the connector on wire harness side as
shown in the chart.
Standard:
Connect the connector to the turn signal flasher and inspect
the wire harness side connector ...
Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal)
Turn the ignition switch to on.
measure voltage between terminals ts and cg of dlc3.
Ok:
voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
Check for open and short circuit in harness and connector between
...