Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Throttle/pedal position
sensor/switch ”a” circuit
Toyota Corolla (E120): Throttle/pedal position sensor/switch ”a” circuit
Dtc p0120 throttle/pedal position sensor/switch ”a” circuit
Dtc p0122 throttle/pedal position sensor/switch ”a” circuit low input
Dtc p0123 throttle/pedal position sensor/switch ”a” circuit high input
Hint
: this is the purpose for the ”throttle position sensor”.
Other materials:
Overhaul
1. Remove roof headlining assy
2. Remove sliding roof glass sub–assy
using a torx wrench (t25), remove the 4 screws the sliding roof
glass.
pull the glass upward to remove it.
3. Remove sliding roof weatherstrip
4. Remove sliding roof drive gear sub–assy
Notice:
...
Oxygen sensor monitor (front and rear o2s system)
Preconditions
The monitor will not run unless:
mil is off
drive pattern
connect the obd ii scan tool to the dlc3 to check monitor status
and preconditions.
Start the engine and allow it to idle for 2 minutes or more.
Drive the vehicle at 25 mph ...
Overhaul
1. Remove w/head taper screw plug no.2
Using a socket hexagon wench 10, remove the taper
screw plug and gasket.
2. Remove valve lifter
Remove the valve lifters from the cylinder head.
3. Remove valve
Place the cylinder head on wooden blocks.
using sst, compres ...