Toyota Corolla (E170): Theft deterrent system

Share this page:

Other materials:

Engine mechanical
Preparation Sst Recomended tools Ssm Equipment Exhaust Preparation Equipment ...

Inspection procedure
1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...

Inspection procedure
Hint: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using the hand–held tester. 1 Read value of hand–held tester(skid control sensor) Check that there is no difference between the speed value output from the speed sensor ...