Toyota Corolla (E120): Theft deterrent & door lock

Share this page:

Other materials:

Inspection procedure
1 Inspect transmission wire(s1) Disconnect the transmission wire connector from the transaxle.  measure the resistance according to the value(s) in the table below. Standard: 2 Check harness and connector(transmission wire – ecm) Connect the transmission connec ...

Dtc check/clear
1. Dtc check (normal mode) Notice: hand–held tester only: when the diagnostic system is switched from the normal mode to the check mode, all the dtcs and freeze frame data recorded in the normal mode will be erased. So before switching modes, always check the dtcs and freeze frame data, and ...

Check dlc3
The vehicle’s ecm uses the iso 9141–2 for communication protocol. The terminal arrangement of the dlc3 complies with sae j1962 and matches the iso 9141–2 format. Hint: if the display shows unable to connect to vehicle when you have connected the cable of the obd ii scan tool or the h ...