Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Cruise control system / Terminals of ecu
Toyota Corolla (E120): Terminals of ecu
Oscilloscope wave (*1)
Hint
:
- terminal: od – gnd
- gauge set: 5 v / div, 50 ms / div
- condition: during cruise control driving o/d switch on.
Other materials:
Overhaul
Hint: components:
1. Drain manual transaxle oil (m/t transaxle)
torque: 39.2 Nvm (400 Kgf·cm, 29 ft·lbf)
2. Drain automatic transaxle fluid (a/t transaxle)
torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf)
3. Remove front wheel
4. Remove engine under cover lh
5. Remove front axle hub lh nut
...
Oxygen sensor monitor (front and rear o2s system)
Preconditions
The monitor will not run unless:
mil is off
drive pattern
connect the obd ii scan tool to the dlc3 to check monitor status
and preconditions.
Start the engine and allow it to idle for 2 minutes or more.
Drive the vehicle at 25 mph ...
Dialing from call histories
1 Select “All calls”, “Missed calls”, “Incoming calls” or “Outgoing calls” using
.
2 Select the desired number using
and press the off-hook switch.
The following operations can be performed:
● Registering a number as a speed dial
Press (Add S. Dial) and then press
an ...