Toyota Corolla (E120): Terminals of ecu

1. Radio receiver assy

Problem symptoms table

    Share this page:

    Other materials:

    Inspection procedure
    1 Input signal check See input signal check on page 05–745. check the indicator light operation when each of the set/ coast, resume/accel and cancel is turned on. Ok: set/coast, resume/accel switch: the signals shown in the table on the left should be output when each switch is ...

    Toyota Safety Sense 3.0 software update
    It is necessary to enter a connected services contract, provided by Toyota, to use these functions. For details, contact your Toyota dealer. WARNING ■For safe use When the Toyota Safety Sense 3.0 software is updated, the operating methods of functions may change. Using this system without knowing ...

    Oxygen sensor monitor (front and rear o2s system)
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...