Toyota Corolla (E120): Terminals of ecu

Problem symptoms table

    Share this page:

    Other materials:

    Fail–safe chart
    If any of the following codes is recorded, the ecm enters the fail–safe mode. Check for intermittent problems Hand–held tester only: by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is possible instead of the 2 trip detection logic, and the sensitivity to de ...

    Circuit description
    The purpose of this circuit is to prevent the engine from stalling while driving in lock–up condition, when brakes are suddenly applied. When the brake pedal is depressed, this switch sends a signals to the ecm. Then the ecm cancels the operation of the lock–up clutch while braking is i ...

    Inspection procedure
    1 Check harness and connector(transmission control switch – body ground) Disconnect the transmission control switch connector of shift lever assy. measure the resistance according to the value(s) in the table below. Standard: 2 Inspect transmission control switch M ...