Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Electronic controlled automatic transaxle / Terminals of ecm
Toyota Corolla (E120): Terminals of ecm
*1: W/ cruise control
Other materials:
Inspection procedure
1 Inspect shift solenoid valve(s1)
Remove the shift solenoid valve s1.
measure the resistance according to the value(s) in the
table below.
Standard:
Connect the positive (+) battery lead to the solenoid connector
terminal, and the negative (–) battery lead to the
solenoid ...
How to proceed with troubleshooting
Hint:
carry out troubleshooting in accordance with the procedures on the following
page. Here, only the basic
procedures are shown. Details are provided in the diagnostics section, showing
the most effective methods
for each circuit. Confirm the troubleshooting procedures first for the releva ...
Evap monitor (vacuum pressure monitor)
Notice:
a cold soak must be performed prior to conducting the drive pattern to complete
the internal pressure
readiness monitor.
Cold soak preconditions
The monitor will not run unless:
mil is off.
Fuel level is approximately 1/2 to 3/4.
Altitude is 7800 feet (2400 m) or less.
...