Toyota Corolla (E120): Tc terminal circuit

Share this page:

Other materials:

Pressing power switch does not start system
Wiring diagram Inspection procedure 1 Inspect radio receiver assy(+b, acc, gnd) Check that the continuity between terminals at each condition, as shown in the chart. Standard: Check that the voltage between terminals at each condition, as shown in the chart. Standard: ...

Inspection procedure
1 Check connector Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  check the connection of the combination meter connector and the airbag sensor assy center connectors. Ok: the connectors are connected. 2 Check combination ...

Changing gear steps in the M position
To enter 7-speed sport sequential shiftmatic mode, shift the shift lever to M. Gear steps can then be selected by operating the shift lever, allowing you to drive in the gear step of your choosing. 1 Upshifting 2 Downshifting The gear changes once every time the shift lever is operated. The ...