Toyota Corolla (E170): Taking out the spare tire

1 Remove the luggage floor cover. 2 Remove the tool tray.

3 Loosen the center fastener that secures the spare tire.

3 Loosen the center fastener that secures the spare tire.

CAUTION

CAUTION

■When storing the spare tire

Be careful not to catch fingers or other body parts between the spare tire and the body of the vehicle.

    Share this page:

    Other materials:

    Starting system
    Inspection 1. Inspect starter assy Notice: these tests must be performed within 3 to 5 seconds to prevent burnout of the coil.  perform the pull–in test.  Remove the nut, then disconnect the lead wire from terminal c. Connect the battery to the starter repai ...

    Malfunction in water temperature receiver gauge
    Wiring diagram Inspection procedure 1 Read value of hand–held tester Check output value of ecm.  Connect the hand–held tester to dlc3.  Turn the ignition switch to on and push the hand–held tester main switch on.  Select the data list mode on the hand–he ...

    On–vehicle inspection
    1. Inspect refrigerant pressure with manifold gauge set  this is a method in witch the trouble is located by using a manifold gauge set. Read the manifold gauge pressure when the these conditions are established. Test conditions: temperature at the air inlet with the switch set ...