Toyota Corolla (E120): System voltage

Dtc p0560 system voltage

Share this page:

Other materials:

On–vehicle inspection
1. Washer motor Operation check pour the water into the washer jar with the washer motor and the pump installed to the washer jar assy.  Connect the battery (+) to terminal 2 of the washer motor and the pump, the battery (–) to terminal 1 of the washer motor and the pump ...

On–vehicle inspection
1. Inspect drive belt Visually check the belt for excessive wear, frayed cords, etc. If any defect is found, replace the drive belt. Hint: cracks on the rib side of a belt are considered acceptable. If the missing chunks from the ribs are found on the belt, it should be replaced. 2 ...

Inspection procedure
1 Inspect terminal voltage(idl) Remove the cruise control ecu assy with connector still connected.  disconnect the ecm connector.  turn the ignition switch to on.  measure voltage between terminal 13 (idl) of cruise control ecu assy connector and body ground when the ...