Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Supplemental restraint system
Toyota Corolla (E120): Supplemental restraint system
- How to proceed with troubleshooting
- Pre–check
- Diagnostic trouble code chart
- Terminals of ecu
- Problem symptoms table
- Short in d squib circuit
- Open in d squib circuit
- Short in d squib circuit (to ground)
- Short in d squib circuit (to b+)
- Short in p squib circuit
- Open in p squib circuit
- Short in p squib circuit (to ground)
- Short in p squib circuit (to b+)
- Short in side squib (rh) circuit
- Open in side squib (rh) circuit
- Short in side squib (rh) circuit (to ground)
- Short in side squib (rh) circuit (to b+)
- Short in side squib (lh) circuit
- Open in side squib (lh) circuit
- Short in side squib (lh) circuit (to ground)
- Short in side squib (lh) circuit (to b+)
- Seat belt buckle switch (lh) malfunction
- Short in p/t squib (rh) circuit
- Open in p/t (rh) circuit
- Short in p/t squib (rh) circuit (to ground)
- Short in p/t squib (rh) circuit (to b+)
- Short in p/t squib (lh) circuit
- Open in p/t squib (lh) circuit
- Short in p/t squib (lh) circuit (to ground)
- Short in p/t squib (lh) circuit (to b+)
- Airbag sensor assy malfunction
- Harf connection in airbag sensor assy connector
- Side airbag sensor assy (rh) malfunction
- Side airbag sensor assy (lh) malfunction
- Seat position airbag sensor malfunction
- Front airbag sensor (rh) malfunction
- Front airbag sensor (lh) malfunction
- Short in d squib (2nd step) circuit
- Open in d squib (2nd step) circuit
- Short in d squib (2nd step) circuit (to ground)
- Short in d squib (2nd step) circuit (to b+)
- Short in p squib (2nd step) circuit
- Open in p squib (2nd step) circuit
- Short in p squib (2nd step) circuit (to ground)
- Short in squib (2nd step) circuit (to b+)
- Source voltage drop
- Srs warning light circuit malfunction (always light up, when dtc is not output)
- Srs warning light circuit malfunction (does not light up, when ignition switch is turned to on)
- Tc terminal circuit
Other materials:
Stopping
► Automatic transmission or continuously
variable transmission
1 With the shift lever in D, depress the brake pedal.
2 If necessary, set the parking brake.
If the vehicle is to be stopped for an extended period of time, shift the shift
lever to P or N. (, 174, 176) ► Manual ...
Manual transaxle oil
On–vehicle inspection
1. Inspect transaxle oil
Stop the vehicle on the level place.
remove the transmission filler plug and gasket.
check that the oil surface is within 5 mm (0.20 In.) From the
lowest position of the inner surface of the transmission filler
plug openin ...
Inspection procedure
1 Check p/t squib(lh) circuit(airbag sensor assy center – front seat
outer belt assy lh)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the seat belt pretensio ...