Toyota Corolla (E120) 2002–2008 Repair Manual / Supplemental restraint system

Toyota Corolla (E120): Supplemental restraint system

Share this page:

Other materials:

Removal & installation and disassembly & reassembly
1. Remove oxygen sensor Remove a clip and tear off the floor mat.  disconnect a oxygen sensor connector. Remove the oxygen sensor. 2. Remove tail pipe assy Remove 2 bolts, 2 springs and tail pipe assy. 3. Remove floor panel brace front Remove 2 nuts and the ...

Oxygen sensor monitor (front and rear o2s system)
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

Inspection
1. Cooler thermistor no.1 Check resistance between terminals 1 and 2 of cooler thermistor no. 1 At each temperature, as shown in the chart. Resistance: If resistance value is not as specified, replace the sensor. 2. Cooler and accessory assy Inspect blower switch contin ...