Toyota Corolla (E170): Sun visors

1 To set the visor in the forward position, flip it down.

2 To set the visor in the side position, flip down, unhook, and swing it to the side.

Vanity mirrors

    Share this page:

    Other materials:

    Inspection procedure
    Hint: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using the hand–held tester. 1 Perform active test by hand–held tester(abs motor relay) Check the operation sound of the abs motor individually when operaing it with the ...

    Fail–safe chart
    If any of the following codes is recorded, the ecm enters the fail–safe mode. Check for intermittent problems Hand–held tester only: by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is possible instead of the 2 trip detection logic, and the sensitivity to de ...

    Inspection procedure
    1 Check operation(overdrive) Drive the vehicle after the engine warms up.  check that overdrive on e off occurs by an operation of the o/d switch on–off. 2 Inspect terminal voltage(od) Remove the cruise control ecu assy with the connector still connected.  tur ...