Toyota Tacoma manuals

Toyota Corolla Repair Manual: Starting system

Inspection

1. Inspect starter assy

Notice:

Notice

: these tests must be performed within 3 to 5 seconds to prevent burnout of the coil.

  1.  perform the pull–in test.
  1.  Remove the nut, then disconnect the lead wire from terminal c.

  1. Connect the battery to the starter repair service kit as shown in the illustration. Check that the clutch pinion gear is extended.

If the clutch pinion gear is not extended, replace the starter repair service kit.

  1. Perform the hold–in test.
  1.  Disconnect the negative (–) lead from terminal c with the lead wire disconnected from terminal c.

    Check that the clutch pinion gear remains extended.

If the clutch pinion gear returns, replace the starter repair service kit.

  1. Check the clutch pinion gear returns.
  1.  Disconnect the negative (–) lead from the starter body. Check that the clutch pinion gear returns.

If the clutch pinion gear does not return, replace the starter repair service kit.

  1. Perform the no–load performance test.
  1.  Connect the lead wire to terminal c with the nut.

    Make sure that the lead is not grounded.

    Torque: 10 nvm (102 Kgf·cm, 7 ft·lbf)

  1. Clamp the starter in a vise.
  2.  Connect the battery and an ammeter to the starter as shown in the illustration.
  3.  Check that the starter rotates smoothly and steadily with the clutch pinion gear extended. Check that the ammeter reads the specified current.

    Specified current: 90 a or less at 11.5 V

If the current is not as specified, replace the starter repair service kit.

2. Inspect starter relay assy

  1. Check the continuity.
  1.  Using an ohmmeter, check for continuity between each terminal.

Specified condition:

If the result is not as specified, replace the starter relay.

If the result is not as specified, replace the starter relay.

Starting & charging
...

Starter assy (1zz–fe)
...

Other materials:

Inspection procedure
1 Check voltage at ig2 of airbag sensor assy center Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connector of the airbag sensor assy center.  connect the negative (–) terminal cable to the battery, and wait a ...

Message Settings
1 Display the “Phone/Message Settings” screen. 2 Select “Messaging Settings”. 3 Select the desired item to be set. 1 Set automatic message transfer on/off. 2 Set automatic message readout on/off. 3 Set the SMS/MMS notification popup on/off. 4 Set the e-mail notification popup on/off. 5 Set add ...

Bluetooth® (Multimedia system)
Bluetooth® ■When using the Bluetooth® audio system ●In the following conditions, the system may not function. • If the portable audio player is turned off • If the portable audio player is not connected • If the portable audio player’s battery is low ●There may be a delay if ...

© 2011-2024 Copyright www.tcorolla.net