Toyota Corolla (E120): Starting & charging

Share this page:

Other materials:

Replacement
Hint: installation is in the reverse order of the removal. But the installation is indicated only when it has a point. 1. Remove luggage compartment door cover 2. Remove rear spoiler  remove the 2 screws.  disconnect the wire harness connector.  put protective tape. &nb ...

Inspection procedure
Hint: read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, it is useful for determining whether the vehicle was running or stopped, the engine was warmed up or not, the ...

Oxygen sensor monitor (front and rear o2s system)
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...