Toyota Corolla (E120): Starter assy (1zz–fe)

Share this page:

Other materials:

Terminals of ecu
1. Inspect integration relay Disconnect the connector from the integration relay. check the continuity between each terminal of the disconnected connector and the body ground, as shown in the illustration and table. Standard: If the result is not as specified, the vehicle’s ...

Shift position uses
*: Shifting to the D position allows the system to select a gear suitable for driving conditions. Setting the shift lever to the D position is recommended for normal driving. ■Downshifting restrictions The shift lever cannot be downshifted if the following speeds are exceeded. mph (km ...

Check and replace ecu
Notice: start an inspection of the connector from the backside of the connector on the wire harness side with the connector connected to the ecu. When no measurement condition is specified, perform the inspection with the engine stopped and also the ignition switch on. First check the ec ...