Toyota Corolla (E120): Stabilizer bar rear

Replacement

Hint

: components:

1. Remove stabilizer bar rear

  1. Remove the 2 bolts, nuts and stabilizer bar.

2. Install stabilizer bar rear

  1. Install the 2 bolts, nuts and stabilizer bar.

    Torque: 195 nvm (1,990 Kgf·cm, 144 ft·lbf)

H

int

: install the stabilizer bar so that the mark is positioned onthe rear right side of the vehicle.

    Share this page:

    Other materials:

    On–vehicle inspection
    1. Inspect wireless door lock control functions Hint: the switch described in this text is a switch for transmitting signals (lock switch, unlock switch and panic switch) which is built into the door control transmitter. All the functions listed below must be checked in the remote contro ...

    Thermostat
    Replacement 1. Remove engine under cover rh 2. Drain coolant 3. Remove fan and generator v belt 4. Remove generator assy Disconnect the wire clamp from the wire clip on the rectifire end frame.  remove the rubber cap and nut, and disconnect the alternator wire.  d ...

    Center stop lamp assy
    Replacement 1. Remove package tray trim panel assy (w/o rear spoiler) 2. Remove center stop lamp assy (w/o rear spoiler) Remove the center stop light assy as shown in the illustlation. 3. Remove center stop lamp assy (w/ rear spoiler) Remove the 2 screws.  disconnect th ...