Inspection procedure
1 Inspect terminal voltage(od – body ground)
Disconnect the cruise control ecu connector.
turn the ignition switch to the on position.
measure the voltage between terminal od of cruise control
ecu and body ground.
Standard:
2 Inspect terminal voltage(od1 – body gr ...
Concept, General information, Safety information
Concept
The lane departure warning alerts when the vehicle
on roads with lane markings is about to leave
the lane.
General information
This camera-based system warns starting at a
minimum speed.
The minimum speed is country-specific and is
displayed in the menu for the intelligent Safety
systems.
...
On–vehicle inspection
1. Inspect turn signal flasher relay circuit
Disconnect the connector from the turn signal flasher
relay and inspect the connector on wire harness side as
shown in the chart.
Standard:
Connect the connector to the turn signal flasher and inspect
the wire harness side connector ...