Toyota Corolla (E120): Source voltage drop

Share this page:

Other materials:

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

Front wheel alignment
Adjustment 1. Inspect tire 2. Measure vehicle height Vehicle height: Measuring points: a: ground clearance of front wheel center b: ground clearance of lower suspension arm front bolt center c: ground clearance of axle beam set bolt center d: ground clearance of rear wheel center Not ...

Power point socket assy
Replacement Hint: components: 1. Remove floor shift shift lever knob sub–assy (m/t transaxle) 2. Remove console panel upper 3. Remove power point socket assy Turn the socket in the circumference direction as shown the illustration, disengage the claw between the socket and the pow ...