Toyota Corolla (E120): Sliding roof/convertible

Preparation

Recomended tools

Equipment

Equipment

Engine hood/door

    Share this page:

    Other materials:

    Inspection and adjustment procedure
    1 Tire valve 2 Tire pressure gauge 1 Remove the tire valve cap. 2 Press the tip of the tire pressure gauge onto the tire valve. 3 Read the pressure using the gauge gradations. 4 If the tire inflation pressure is not at the recommended level, adjust the pressure. If you add too much air, pres ...

    Inspection procedure
    1 Input signal check See input signal check on page 05–745. check the indicator light operation when each of the set/ coast, resume/accel and cancel is turned on. Ok: set/coast, resume/accel switch: the signals shown in the table on the left should be output when each switch is ...

    Rear wheel alignment
    Inspection 1. Inspect tire 2. Measure vehicle height Notice: before inspecting the wheel alignment, adjust the vehicle height to the specified value. 3. Inspect toe–in Toe–in: usa, canada: Mexico: If the toe–in is not within the specified value, inspect and replace the susp ...