Toyota Corolla (E120) 2002–2008 Repair Manual / Brake / Skid control sensor
Toyota Corolla (E120): Skid control sensor
Replacement
Hint
: replace the rh side by the same procedure as the lh side.
1. Remove rear wheel
2. Remove rear brake drum sub–assy
3. Disconnect skid control sensor wire
- Disconnect the skid control sensor wire connector from the skid control sensor.
4. Remove rear axle hub & bearing assy lh
5. Remove skid control sensor
- Mount the rear axle hub in a soft jaw vise.
Notice
: replace the axle hub assembly if it is dropped or a strong shock is given to it.
- using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from sst.
- using sst and 2 bolts (diameter: 12 mm, pitch: 1.5 Mm),
remove the skid control sensor from the rear axle hub.
Sst 09520–00031 (09520–00040), 09521–00020, 09950–00020
N
otice
:
- if a damage is inflicted to the sensor rotor, replace the axle hub assembly.
- Do not scratch the contacting surface of axle hub and speed sensor.
6. Install skid control sensor
- clean the contacting surface of the axle hub and a new
speed sensor.
Notice
: do not stick any foreign objects to the sensor rotor.
- place the speed sensor on the axle hub so that the connector makes the lowest position under the on–vehicle condition.
- Using sst and press, install the new speed sensor to the
axle hub.
Sst 09214–76011
7. Install rear axle hub & bearing assy lh
8. Connect skid control sensor wire
- Connect the skid control sensor wire connector to the skid control sensor.
9. Install rear brake drum sub–assy
10. Install rear wheel
torque: 103 nvm (1,050 Kgf·cm, 76 ft·lbf)
11. Inspect and adjust rear wheel alignment
12. Check abs speed sensor signal
Other materials:
Adding a new phone number
Select “Add contacts” using . ●
Transferring all contacts from the cellular phone
Select “Overwrite all contacts” using
and press
(YES).
● Transferring one contact from the cellular phone
Select “Add one contact” using and
press (YES). ...
Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have blown.
If this happens, check and replace the fuses as necessary.
1 Turn the engine switch off.
2 Open the fuse box cover.
► Engine compartment
Push the tab in and lift the lid off.
► Under the driver’s side i ...
Engine mechanical
Service data
Torque specification
...