Toyota Corolla (E120): Side air bag sensor assy rh

Share this page:

Other materials:

Inspection procedure
1 Check d squib circuit(airbag sensor assy center – horn button assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the horn button assy and the airbag sensor assy center.  for the blac ...

Inspection procedure
1 Check wire harness(dlc3 – airbag sensor assy center) Turn the ignition switch to the lock position.  disconnect the aribag sensor assy center connector.  measure the resistance according to the value(s) in the table below. Standard: 2 Check wire harness(cg of dl ...

Oxygen sensor monitor (front and rear o2s system)
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...