Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Supplemental restraint system / Short in squib (2nd step) circuit (to
b+)
Toyota Corolla (E120): Short in squib (2nd step) circuit (to b+)
Dtc b1188/56 short in squib (2nd step) circuit (to b+)
Other materials:
Inspection procedure
1 Input signal check
See the input signal check on page 05–745.
check the indicator light when the clutch pedal is depressed.
Ok:
the indicator light goes off when the clutch pedal is
depressed.
2 Inspect terminal voltage(d)
Turn the ignition switch to on.
&n ...
Removal & installation and disassembly & reassembly
1. Remove oxygen sensor
Remove a clip and tear off the floor mat.
disconnect a oxygen sensor connector.
Remove the oxygen sensor.
2. Remove tail pipe assy
Remove 2 bolts, 2 springs and tail pipe assy.
3. Remove floor panel brace front
Remove 2 nuts and the ...
Inspection procedure
1 Check side squib(lh) circuit(airbag sensor assy center – front
seat airbag assy lh)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the front seat airbag assy ...