Toyota Corolla (E120): Short in side squib (rh) circuit (to ground)

Dtc b0112/41 short in side squib (rh) circuit (to ground)

Share this page:

Other materials:

Inspection
1. Inspect defogger relay (marking: def) Remove the defogger relay from the instrument panel j/b.  inspect the defogger relay. Standard: If the result is not as specified, replace the relay ...

Overhaul
1. Remove generator pulley Sst 09820–63010 (09820–06010, 09820–06020) Hint: Hold sst 1 – a with a torque wrench, and tighten sst 1 – b clockwise to the specified torque. Torque: 39 nvm (398 Kgf·cm, 29 ft·lbf) Notice: check that sst is secured to the rotor shaft. ...

Check short circuit
If the wire harness is ground shorted as shown in fig. 5, Locate the section by conducting a resistance check with the body ground in step (b). Check the resistance with the body ground.  Disconnect connectors a and c and measure the resistance between terminals 1 and 2 ...